Skip to main content

CS601 Current Midterm Paper Fall 2013 File 3


Shared by Hira Ghumam


Mine todays paper of cs601
Mcqs (20 marks)
Q21. Define the Audio frequency spectrum?(2 marks)
Answer:
Audio frequency spectrum is measured in Hertz's (Hz) and tells the range of audible audio. The human hearing range is usually 20-20000Hz, but especially the audibility of the top end of the spectrum declines with age. Most software analyzers measure between 0 Hz and 16000-24000kHz
Q22.Explain the function of  DCE,DTE in the network?(2 marks)
Answer:
DTE(Data terminal Equiment)
DCE(Data circuit terminating Equiment )

Q23.we have an audio signal with a BW of 10HZ .what is the BW needed if we Modulate the signalusing AM? (3 marks)
Answer: AM=Twice of band width
BW=Band width
BW=2*10HZ=20KHZ
AM=20KHZ
Q24.write the degree when the cycle is complete in the frequency modulation?
1)Full cycle
2)Half cycle
3)Quarter cycle              (3 marks)
Q25.In the radio transmition when we  convert anolge signal in to the digital signal which senior is required explain ?(5marks)
Q26.Explain the convertion Digital to analog in
Efect of Baud rate
Efect of noise
Efect of tranmision speed

Best of luck all

Comments

Popular posts from this blog

CS504 Quiz No.3 Shared by Angel

Question # 1 of 10 ( Start time: 09:08:01 PM ) Total Marks: 1 Defining the services of an object means: Select correct option: What it does?        ok What it knows? Who knows it? Whome it knows? Question # 2 of 10 ( Start time: 09:08:27 PM ) Total Marks: 1 Which one of these represents the Krutchen’s 4+1 architectural view model? Select correct option: Logical view, Process view, Physical view, Development view, Use case view Logical view, Dynamic view, Physical view, Development view, Use case view Logical view, Process view, Physical view, Development view, Sequence view Dynamic view, Process view, Physical view, Development view, Use case view Question # 3 of 10 ( Start time: 09:09:50 PM ) Total Marks: 1 Return values in Synchronous messages are represented by: Select correct option: A solid line A dotted line with label        ok A solid line with label Double line Question # 4 of 10 ( Start tim...

CS302 Quiz No.4 Shared by Jawwad

Question # 1 of 10 ( Start time: 01:15:08 PM ) Total Marks: 1  Asynchronous mean that_____________  Select correct option:  Each flip-flop after the first one is enabled by the output of the preceding flip-flop  Each flip-flop is enabled by the output of the preceding flip-flop  Each flip-flop except the last one is enabled by the output of the preceding flip-flop  Each alternative flip-flop after the first one is enabled by Question # 2 of 10 ( Start time: 01:16:36 PM ) Total Marks: 1 A divide-by-10 ring counter requires a minimum of Select correct option: ten flip-flops five flip-flops four flip-flops twelve flip-flops Question # 3 of 10 ( Start time: 01:17:00 PM ) Total Marks: 1 When the number of states are reduced during the design any counter Select correct option: output changes and Input remain unchanged Input changes and output remain unchanged Input and output bith change Input and output remain unchanged Question # 4 of...

CS614 Quiz No.1 Shared by Manzar (UnSolved)

Question # 1 of 10 ( Start time: 03:35:24 PM )   Total Marks: 1 MDX by Microsoft is an example of _______ Select correct option: HOLAP DOLAP ROLAP None of the given options Question # 2 of 10 ( Start time: 03:36:40 PM )   Total Marks: 1 In decision support system ease of use is achieved by: Select correct option: Normalization Denormalization Drill up Drill down Question # 3 of 10 ( Start time: 03:38:07 PM )   Total Marks: 1 Which of the denormalization technique squeezes master table into detail? Select correct option: Pre-joining Horizontal splitting Vertical splitting Adding redundant column Question # 4 of 10 ( Start time: 03:38:28 PM )   Total Marks: 1 The trade-offs of denormalization is/are: Select correct option: Storage Performance Ease-of-use All of the given options Question # 5 of 10 ( Start time: 03:38:46 PM )   Total Marks: 1 ________is usually deployed when expressions can be used to group data together in...